Skip to content
Back to all Knowledge base

Sustainability of a stainless steel pool

What the construction method contributes, what it does not, and where the largest gains in a pool’s environmental impact are found.

Stainless steel pool panels being dismantled for reuse

Where the impact lies

A pool’s environmental impact comes from two phases: building it and running it. Running it, with heated water and air, ventilation, pumps and water use, accounts for the largest share over its life. Construction still matters. Concrete and reinforcing steel carry a large amount of embodied carbon, and demolishing and rebuilding a pool every few decades adds to that.

This page sets out what a stainless steel pool contributes, from construction to end of life.

Lower embodied carbon in construction

The Australian engineering firm ACOR Consultants compared the energy needed to build a Myrtha pool and a traditional concrete pool, including materials and transport. For a pool of 50 × 25 × 2 m the result was about 1.8 million MJ against 3.7 million MJ, and about 180 tonnes of CO₂ against 362 tonnes: roughly 50% less. For a pool of 25 × 25 m the reduction was 52%.

Transport and building site

  • An Olympic-size pool is shipped in two 40-foot containers.
  • Panels are carried in by hand or by lift, without heavy machinery.
  • There is no curing period and no structural water test. A new concrete tank is usually filled and monitored before finishing; in the independent UK study this meant about 800 m³ of water that was used once and drained.
  • Less formwork, reinforcement and wet work on site means less site waste.

Renovate instead of rebuild

The most sustainable pool is often the one that already exists. With RenovAction, a new stainless steel pool is built inside the existing concrete shell. The shell stays in place, so there is far less demolition waste and new concrete than with a complete rebuild. Read more in Renovate or rebuild?

End of life

Stainless steel is fully recyclable and has a real scrap value, so it is collected and reused rather than landfilled. The panels are bolted, not cast, so a pool can be taken apart partly or completely.

LEED, BREEAM and Green Star

Myrtha has had its pool systems mapped against LEED v4 (2019) and against BREEAM and Green Star (2020). This helps a design team see which credits the pool can contribute to. Myrtha Breathe can add to this through indoor air quality. Certification always applies to the building as a whole; see Sustainable buildings.

Products

Related products

Knowledge

Read more